Kevlar 2s Battery Straps RC8B4e / T4e

Secure your 2s batteries into the Team Associated RC8B4e and RC8T4e with durable kevlar woven Schelle logo battery straps!   Custom sized for 2s with perfect fuzzy/spikey hook and loop ... they are a dream to use and get your packs in and out of the vehicle!

1. Durable max width kevlar
2. Custom sized for 2s
3. Length 8.75" or 345mm
4. Easy install (you may need to flex the slot open a bit to get it started).  Check and make sure the buckles are on the centerline of the vehicle.
5. Blingy
6. 2 pcs. included   Check out the 4 pack for $16 as well!

Installation:

1. Remove ebuggy trays off the chassis.   45 angle trim any sharp corners.I put both buckles to the center of the car.
2. Straps go around outside of tray, align so logo will end on top after folded...then un-fold and slide thru the slot top to bottom.(use a small flat blade to pry the gap wider to get it started).  Wrap embroidery with painter tape to protect if needed.
3. Set the buckle end so the height is the same as a battery, the buckle bends at the edge of the shorty pack